Toro lawn sprinklers are typically used in residential lawns in automatic watering systems. These save the house owner time and aggravation native trying come water by hand and they conserve on water as well.
You are watching: Toro super 800 sprinkler head replacement
When the sprinkler begins to leak or is damaged by a lawn mower, this usually means that part or every one of the sprinkler head needs to it is in replaced. If the nozzle is the only part damaged, then you deserve to just replace the nozzle. Otherwise, you will should replace the whole sprinkler head.
Pry increase the nozzle through the screwdriver and pull increase the pop-up head with your fingers.
Hold on come the pop-up head through one hand and also unscrew the nozzle with the other. Don"t let go of the pop-up head, due to the fact that it may be an overwhelming to pull it increase again without a nozzle.
Remove the old plastic screen and replace it with a new one. The display screen keeps dust from entering her sprinkler system. The nozzle holds it in place, so that should simply lift out with the nozzle removed.
Screw on the brand-new nozzle, however don"t let walk of the pop-up head.
Adjust the spray sample of the nozzle come fit her needs. This is done assorted ways relying on the kind of nozzle. The new nozzle will certainly come with instructions on just how to change it.
Turn ~ above the sprinklers to test the repaired sprinkler.
Repeat procedures 5 and 6 till the sprinkler is adjusted and functioning correctly.
Start digging by cut straight into the turf v the shovel number of inches indigenous the sprinkler head. Make a finish circle around the head if a sidewalk or driveway is not in the way. Pull out the sod and collection it off to the side. Try to store it in simply one or 2 pieces.
Continue digging the hole. Dig deep enough to disclose at the very least 1 inch of the pipeline the head is connected to. The trowel may be easier to usage to dig with since of the tight confines of the hole.
Unscrew the head from the pipe.
Turn top top the water because that several seconds to flush out the pipe.
Screw the new head ~ above the pipe.
Turn ~ above the water to test the sprinkler. Watch for any significant leaks.
Make certain the sprinkler is right by utilizing the level in 2 perpendicular directions.
Fill in the dirt and also periodically inspect that the sprinkler remains level. Use your foot to tamp the dirt down prior to replacing the sod.
Adjust the nozzle ~ above the sprinkler (See measures 5 v 7 in Nozzle Replacement).
Things You will Need+
brand-new cap and screen little straight slot screwdriver brand-new sprinkler head Shovel Trowel small straight slot driver Level
Use the same design of sprinkler because that replacement or at the very least make certain they space the very same height, otherwise the new sprinkler won"t lie flush v the ground.
See more: Who Sang The National Anthem At The Cowboys Game Today, Who Is Michelle Williams
Don"t dig as well aggressively roughly the sprinkler, specifically as you acquire to the bottom. The sprinkler commonly is linked to an elbow joint, therefore the horizontally to run PVC water pipeline is not really deep. A shovel have the right to dig into it and also cause more repair headaches.