JavaScript is disabled. Because that a much better experience, please enable JavaScript in your browser prior to proceeding.

You are watching: How much transmission fluid does a 700r4 hold


*

I"m said the 700R4 holds about 11 quarts the fluid.My infection builder says, "Put 6 quarts in the tranny, operation it for about 10 seconds, then include 5 quarts and also run the again."Just feather for second opinions.... Is that the best way to carry out it ???????
68 !!! Damn, if I had known i was going to live this long I would have taken better care of my human body !!
*

Did girlfriend put any kind of fluid in the converter before installing it? I shot to put in a qt or two and install the converter,, the is a good way your tranny man said, simply dont operation it dry, matty man
*

I"m called the 700R4 holds around 11 quarts that fluid.My transmission builder says, "Put 6 quarts in the tranny, run it for about 10 seconds, then include 5 quarts and run it again."Just spring for second opinions.... Is that the best method to carry out it ???????
It"s most likely going to take about 12 qts there is no the deep pan. Put in 5 qts, have actually all her bottles of liquid open. You don"t desire to it is in fiddling approximately opening party of liquid while it"s running. After ~ the 5 qts, begin it up, add the liquid as it"s running. The trans have the right to suck the up faster than you can include the fluid, so don"t hesitate come just negative them all in ideal away. Gain 11 qts in it, then walk inside and put it into every equipment a few times. Include a bit at a time ~ that till it"s at the around the lower end of the 2 currently on the stick. Go journey the car. As soon as you get ago recheck and fill come the complete mark. You don"t want to go to the complete mark best away because if you perform it might end up being overfilled when it heats up due to expansion of the fluid.
Mikehttp://www.mikes-transmissions.com/http://www.tennis2007.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
*

I didn"t even think about a dried converter, since the persons we get are pre-lubed. If your looks dried inside, then by all method add a qt come it.
Mikehttp://www.mikes-transmissions.com/http://www.tennis2007.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
*

I probably screwed this up...Prior to installation the converter ns attempted to to water some fluid in but was just able to get in tiny over 1/2 a quart... I more than likely was not doing that right.Now every little thing is installed including the dust cover.Can I run it together is or carry out I should get much more oil in the converter and also how is that finest accompolished?Thanks !!
68 !!! Damn, if I had known ns was going come live this long I would have actually taken far better care of my body !!
You"ll it is in fine through a fifty percent a qt. Don"t worry about it. I recognize shops that operation dry ones and also say castle don"t have actually problems. Many converters the don"t have some oil in them at least have actually assembly lube, so they truly aren"t dry.
Mikehttp://www.mikes-transmissions.com/http://www.tennis2007.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
Just a reminder once you walk for the test drive, just take it easy, no pedal to the floor starts. I recognize I don"t need to tell you yet sometimes I tend to gain excited and also drop the hammer very first time out. :smileyb:
It"s more than likely going to take around 12 qts without the deep pan. Placed in 5 qts, have all your bottles of fluid open. Girlfriend don"t desire to it is in fiddling roughly opening party of liquid while it"s running. After the 5 qts, start it up, include the fluid as it"s running. The trans have the right to suck that up faster than girlfriend can include the fluid, so don"t hesitate to just bad them all in right away. Get 11 qts in it, then walk inside and put it right into every gear a couple of times. Add a bit at a time ~ that till it"s in ~ the about the lower end of the 2 lines on the stick. Go journey the car. When you get ago recheck and fill to the full mark. Girlfriend don"t desire to go to the full mark ideal away since if you execute it might become overfilled as soon as it heats up due to expansion that the fluid.
whereby did you get the infor because that 12 Qts ???? I have actually a 700r4 just asking never put 12 in this one stock pan ( I included the Drain) smaller 9 1/2 customs converter 2500 /3000stall just asking :dontknow:
Where walk you acquire the infor because that 12 Qts ???? I have actually a 700r4 just asking never put 12 in this one share pan ( I included the Drain) smaller sized 9 1/2 customs converter 2500 /3000stall simply asking :dontknow:
That"s what walk in it with a standard dimension converter. I probably should have asked what diameter converter he"s using. We"ve rebuilt and also installed literally numerous these in the 23 years I"ve to be open. Check out mine website http://www.mikes-transmissions.com/. I"ve been rebuilding trannys for 34 years, an owner for 23. If you want to check out who ns am, click on the YouTube video link top top the website. I"m the man in the beginning of the video. It also shows a few shots of the shop, among my techs and customer testimonials.
Mikehttp://www.mikes-transmissions.com/http://www.tennis2007.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
My wife"s automobile with the 700 calls the end 21.6 pints capacity, because that overhaul, so just under 11 quarts........
My wife"s auto with the 700 calls the end 21.6 pints capacity, because that overhaul, so simply under 11 quarts........
What sort of vehicle is it? A 700 behind a V8 v a full size converter takes 12 Qts. OK, offer or take a 1/2 a Qt. That"s why I just said to walk all the means to 11 then include as necessary. Yet you far better have 12 qts over there or you"ll be quick on fluid.
Mikehttp://www.mikes-transmissions.com/http://www.tennis2007.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
I am using the Precision industries unit (2600 rpm)I think it"s 10" diameter.It"s the same unit Kerno"s runs behind the 540 large block.Arnie
68 !!! Damn, if I had actually known i was going come live this long I would have actually taken better care that my human body !!
Well, her trans will take less fluid. Placed in 5 qts, start motor, walk to 9 qts(including the 1/2 you put in the converter)and start checking the stick. If friend don"t view anything ~ above the stick in ~ all include another qt. Don"t interact it till you see fluid on the stick. Interact it a couple of times right into all the equipment positions then add as necessary to obtain it ~ above the reduced line on the stick(cold mark). Walk for a test drive and when friend return recheck and add as necessary to the greater line(hot mark).
Mikehttp://www.mikes-transmissions.com/http://www.tennis2007.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
The infectious diseases worldwide is not going come be really fussy about the liquid level. It have the right to be a quart low and also work. Gift over full can be much more of a problem. Obtain it close, drive it until it is warm and check that in neutral v the engine running. Include fluid to suit.
Mike, my wife"s auto is a "93 Caddy Fleetwood RWD ( over-dressed Caprice) i was quoting the company manual because that the capacity.

See more: How To Start A New Game In Pokemon Black 2, How Do You Overwrite A Pokemon Save File


Bill, her wifes auto must have actually a slightly smaller sized converter. 12-14 qts is what we placed in depending upon pan depth because that 4L60(700), 4L60E, 4L65E with complete size converters(12 inch).
Mikehttp://www.mikes-transmissions.com/http://www.tennis2007.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352
Yeah Mike, that might be the reason.I was wondering if the transmission may be somewhat various in a car with the trailer package ?? it does have a 3.73 behind end. To be wondering if the trans might be a heavy duty type, if over there is together a thing (?)
Bill, It most likely does have at the very least an external cooler added to the system and maybe different accumulator springs in it because that an ever so slighty firmer shift. Remember most Caddy owners mean a smooooooth change :>)
Mikehttp://www.mikes-transmissions.com/http://www.tennis2007.org/album.php?albumid=8http://www.facebook.com/profile.php?id=100002057136352