good afternoon.

You are watching: 2009 chevy malibu oil pressure sensor location

You did no list the engine size so i attached a picture of both the 1.5 and the 2.0.The move is the end in the open and also is accessed native the bottom that the automobile looking up.Roy
*

*

*

*

gained this indigenous Alldata. Inspect out the diagrams (Below). You re welcome let us know if you require anything else to gain the difficulty fixed. The Medic
*

I have actually an AC-Delco replacement but cannot where it is at. Had actually DTC P06DE. Oil level is fine and engine runs quietly and has no lose of power.
The oil press sensor is item #2 tucked behind the input on the rear of the engine. Inspect out the diagrams (Below). You re welcome let us understand if you need anything rather to gain the difficulty fixed.
ns look under the engine and also I'm having an obstacle on the location. Ns asked mine buddy where could the place be at. Right over the oil traction plug i looked increase ahead and also it to be close to the manifold is a tight spot. Yet if girlfriend can assist I considerably appreciate it.
Hello, i have included the details that you requested in the diagrams down below. That is located right in earlier of the oil filter. Please, if you have any kind of other automobile related questions, feel totally free to ask.Thanks, Alextennis2007.org
Hello, ns have included a diagram of her vehicle's engine and all of the switches and also sensors top top it. The Oil pressure Switch(OPS) is number 11 on the diagram. You re welcome get ago to us through how whatever turns out.Thanks, Alextennis2007.org
I have actually a leak the is coming from above the oil filter housing. I adjusted the oil push switch, however that did no help.I am reasoning about changing the oil filter. Ns am not certain that would help. Just going around the least expensiveway. The leak seems to be coming from the engine above the filter. Might this be valve sheathe gaskets.My engine is v6 3.6lneed help
Make certain it is not leaking indigenous there. The is typical when installing the you have the right to break the plastic top on installation/Roy
I need to replace mine oil pressure sensor and I can't uncover a diagram of the location. Ns am pretty certain I view it however want to be sure. My car provided above is the LT model.
great afternoon, The sensor is above the oil filter. Ns attached two pictures for you come view.RoyRemoval ProcedureimageOpen In new TabZoom/Print 1. Remove the starter. Refer to Starter engine Replacement (LZ4) Starter engine Replacement (LAT) Starter engine Replacement (LY7). 2. Disconnect the engine wiring harness electrical connector (2) from the oil push sensor.ImageOpen In brand-new TabZoom/Print 3. Eliminate the engine oil press sensor.
The sensor the I must replace is slightly below and also to the left of the oil filter. I'm being told the is the oil pressure sensor yet I require confirmation.
carry out you have actually a brand-new sensor? If you do, eliminate the connector from the sensor in the picture and make sure it fits top top the brand-new sensor. That will certainly confirm it.Roy
Car die On Me believed Battery to be Dead therefore Bought A new One. Worked For A Bout A week & currently Its walking Crazy. The Locks room Unlocking &...
I replaced The entry Manifold (lower Gaskets). Everything Is working Fine Except during Reassembly ns Was can not To situate The Vacuum Line...

See more: What Does I Wish You Well Mean Ing, Translation, Wish You Well


Wobbling Crank pillar W/ excessive Squeeling How can I change It? space There Bearings i Should problem About?
Can ns Clean increase This To make Engine Perform better Car Shudders and Die at Stop and also Acts favor Throttle Is Sticking
I simply Purchased A used Car and also Found that The Oil Was as well Full, yet There Was eco-friendly Sludge/or Gell top top The Oil Cap. Is This Antifreeze In...