Changing her engine oil in her Pontiac car is do-it-yourself maintain that have the right to save you the cost of acquisition your vehicle to a mechanic. Changing the oil in the Pontiac car van is similar to an altering the oil in any kind of other petrol engine, inquiry a couple of tools and an easy mechanical knowledge. Happily the Pontiac vehicle employs an oil life system meter top top the instrument swarm that notifies you as soon as to change the oil.

Under The Hood:

How to adjust the Oil in a 2005 Pontiac Montana

Drive the Pontiac Montana for roughly five come 10 minute to warm up the engine oil. This makes the oil much less viscous, make it less complicated to drain.

You are watching: 2007 pontiac grand prix oil filter location

Park the Montana ~ above a flat, even surface and shut the engine off. Communicate the emergency brake.

Place a hydraulic jack beneath the prior jack point. Elevator the prior of the van and place jack was standing on the front side jack points, located behind the front wheels.

Put ~ above Nitrile gloves and safety glasses. Gloves alleviate mess and also safety glasses defend your eyes in case any kind of oil splashes in your face.

Slide in ~ the Montana and locate the oil drainpipe plug ~ above the bottom that the engine oil pan. Position an oil drain receptacle beneath the drain plug.

Remove the oil drain plug with a 12mm wrench. For sure the oil is draining right into the oil drain receptacle. Open up the hood and also unscrew the oil fill cap on the peak of the engine; this help the oil drain easier. Allow the engine oil to totally drain out of the vehicle; this usually takes 30 minute to one hour.

Locate the oil filter beneath the Montana. Position the oil drain receptacle beneath the old oil filter.

Turn the oil filter counterclockwise to eliminate it. Usage an oil filter removal tool if you are having actually trouble remove the filter. Turn the oil filter upside down and allow the oil in the filter to drain out into the oil drain receptacle. Enclose the old filter in a plastic bag and throw it away.

Dip your finger in the new engine oil and rub it follow me the rubber seal on the brand-new oil filter. This problems the seal to assist prevent leakage.

Clean the oil filter mating surface with a rag or shop towel.

Insert the new oil filter on the oil filter post and also screw clockwise till tight. Turn it second 1/2 rotate to ensure tightness. Perform not over tighten or friend may damages the rubber seal.

Clean the oil drain plug with a rag or shop towel. Clean the bottom the the engine oil pan.

Place a new washer on the oil drainpipe plug and also insert it ago into the oil pan. Tighten the oil drain plug come 25 or 30 foot pounds of torque, utilizing a torque wrench.

Open the oil to fill cap and add four quarts the 5W-30 oil. Use a funnel if necessary to add engine oil.

Remove the oil drainpipe receptacle from beneath the engine and also lower the vehicle.

Reset the oil life system light by pushing the "Trip/Reset" switch on the dash till "Oil" displays on the driver info system top top the instrument cluster. Turn the vital to the "Run" position and press the "Trip/Reset" button for five seconds.

Items you will certainly need

Hydraulic jack

Jack stands

Nitrile gloves

Safety glasses

Oil drainpipe receptacle

12mm wrench

Rag or shop towel

Oil filter remove tool

Disposable plastic bag

PF-47 replacement oil filter

5W-30 engine oil, 4.0 quarts

Torque wrench

How to readjust the Oil in a 2006 Pontiac G6

Park her G6 on firm, level ground. Apply the parking brake and also chock the rear wheels.

Remove the engine oil fill cap from the top of the engine. Grasp and pull increase on the lower right corner of the entry manifold cover come disengage the retaining clips hold the cover come the waiting cleaner outlet duct. Grasp and pull up on the left next of the cover to disengage the from the studs, then remove it.

Position the floor jack between 6 and 7 inches from the front pinchweld flange and lift the prior of the automobile one next at a time. Assistance it top top jack stands.

Place the drainpipe pan under the drainpipe bolt and also remove the drain bolt. Once the oil has actually drained, install the bolt and tighten it to 18 foot-pounds. Eliminate the drain pan native under the car and lower her G6 come the ground.

Find the oil filter lid in the front of the engine compartment, low and also just come the driver"s side of center. Remove the cap through the filter wrench or socket. The filter come out through the cap. Remove the filter from the cap.

Install the new filter ~ above the bottom the the oil filter cap and install the cap. Tighten the cap to -- yet do no exceed -- 18 foot-pounds. Pour 4.5 quarts the oil right into the engine.

Position the intake manifold cover end the studs and the air cleaner outlet duct. Push down top top the cover above the left-side studs to engage the retainer clips, then push on the lower-right corner of the sheathe to engage the wait cleaner outlet duct.

Install the engine oil to fill cap. Start the engine and also check because that leaks. Revolve off the engine and wait a few minutes for the oil come drain and also then inspect the oil level, utilizing the dipstick. Add the staying 1/2 quart that oil as needed to carry the oil level to the "Full" mark.

Items you will certainly need

Wheel chocks

Floor jack

2 jack stands

Drain pan


Socket set

Torque wrench

Oil filter wrench, No. J 44887 or a 1 1/4-inch socket

Oil filter, GM part No. 12579143 or equivalent

5 quarts SAE 5W30 oil, meeting GM traditional GM6094M and also displaying the API-certified starburst

How to change the Oil in a 2006 grand Prix

Park the cool Prix top top level ground. Allow the engine come cool off. Ideally, you desire the oil to be warm, as it will flow out that the engine block much better than if the is cold. If the oil is too hot, however, you deserve to be severely burned.

Go under the car and locate the oil drainpipe plug in ~ the bottom that the oil pan.

Put a drain pan underneath the drain plug.

Loosen the drain plug with a socket wrench till it"s loose enough come unscrew through hand. Continue unscrewing the drainpipe plug with your hand, but press against the oil pan while friend unscrew that to prevent the oil native gushing out.

Remove the drain plug from the oil pan and allow the oil to flow into the drain pan. Wipe the oil off the drainpipe plug v an old rag.

Remove the lid labeled "Engine Oil Only" (the oil cap) in the optimal of the engine compartment. This equalizes the push in the engine block and helps the oil to drain out. Enable the oil to drain into the drainpipe pan until the flow is under to a steady drip.

Wipe the oil turn off the area around the drain hole and screw the drain plug earlier into place. Tighten the drainpipe plug through a socket wrench to type a tight seal, however do not over-tighten it, as you deserve to strip the threads and it will autumn out.

Pour the old engine oil from the drain pan right into an old plastic container, prefer an antifreeze or windshield washer fluid container.

Place the drainpipe pan under the oil filter.

Remove the oil filter by unscrewing it from the engine block. If it"s too tight or slippery, usage a filter wrench to ease it, then remove it by hand. Store the open end of the filter encountering up since it still consists of oil.

Cover the gasket on the new oil filter with new oil by dipping your finger in the oil and also running it over the gasket. This helps the brand-new filter slide into position ~ above the engine.

Screw the new filter onto the engine. Rotate it till it"s fairly tight, then add a quarter-turn.

Add the new oil come the engine by putting it through the feet at the top of the engine block. Making use of a funnel can help prevent spills. Replace the oil lid after the oil has been added.

Start the cool Prix up and also let it operation for a few minutes. Revolve it off, then examine the oil level through the dipstick. Add more oil if necessary.

How to readjust the Oil on a Pontiac cool Prix

Park your cool Prix in a level place, turn off the engine, and engage the parking brake. Place blocks behind the behind tires and disconnect the an unfavorable battery cable under the hood. Eliminate the oil dipstick and wipe the clean. If you have been driving your car, wait one hour before beginning your oil adjust to alleviate the temperature of the oil and engine block.

Jack up the prior of the vehicle and lower that onto jack stands. Place the jack stand under a stable spot ~ above the structure to avoid damage to the undercarriage and also to be specific that it will certainly not fall. If you room working on a newer design Grand Prix, it has a sub structure as protest to a complete frame. Check your owners hand-operated for the correct locations to ar the jack and also jack stands.

Under the car, locate the the oil pan and oil plug. The oil pan is the lowest point on the engine, and the plug is a bolt in bottom of the pan. Place the oil record pan listed below the oil plug and remove the oil plug with a properly sized wrench or socket. The oil will drain into the catch pan.

Replace the oil plug and also wipe the area clean with a rag so that you deserve to locate any type of leaks that might arise later.

Place the record pan below the oil filter. The oil filter will be greater up top top the engine, but accessed native under the car. Utilizing an oil filter tool or strap wrench, loosen and also remove the oil filter, allowing any overabundance oil to autumn into the drainpipe pan. Wipe the mating surface ar clean ~ above the engine block and remove any type of oil filter gasket product that has stuck.

Fill the instead of filter and lubricate that rubber seal with new oil. Screw the filter right into place till it makes call with the engine, and then tighten it, by hand, as instructed ~ above the side of the filter or its sleeve box -- commonly 1/4 come 3/4 turn. Tightening too lot may reason the oil seal to separation or make it very an overwhelming to eliminate at the following oil change. Use caution no to cross-thread the filter ~ above the engine block.

While the is much better to have oil in the oil filter as soon as you an initial start your car, part engines carry out not have the oil filter oriented vertically, in which situations the new oil will certainly pour out once reinstalling. In that case, only lubricate the rubber seal and do not fill the filter with oil.

Double check that you have actually reinstalled both the oil plug and the oil filter.

Locate the oil to fill cap on the engine and also remove it. To water the compelled amount of brand-new oil into the engine using a funnel to reduce the possibility of spilling. Recommendation your owners hands-on for the correct kind and lot of oil. Location the dipstick ago in the place and check the oil level, pour it until it is full as required until it is in between the point out on the finish of the stick.

Remove the jack stands and also lower the vehicle back to the ground. To water the old oil right into a sealed container for ideal disposal.

See more: How To Draw A Tortoiseshell Cat, How To Draw Tortoiseshell Cat

Start the grand Prix and permit it to operation for a minute, then revolve it off again and also wait two minutes because that the oil to drain earlier into the oil pan. Examine the oil level once more and include as necessary to carry the level to the "Full" mark. Check below the auto for any leaks close to the oil drain plug or oil filter.