While there are a lot of reasons why an air Conditioning device will no blow cold air on a offered car. Difficulty here is regarded air conditioning low push switch.

This is a 2011 Honda Civic yet this difficulty with same symptoms will happen on other models too (Honda Accord, Honda CR-V…etc). Honda A/C system are very similar if not totally the very same throughout models.

You are watching: 2006 honda accord ac pressure switch location


*
Honda wait Conditioning press Switch location

Honda Intermittent Air air conditioning Operation. waiting conditioning works fine as soon as engine is cold, in the morning or when auto has to be sitting for few hours.

However, after driving for about 15 come 20 minutes and also engine reaches operation temperature that will stop working. Upon check the system discovered that refrigerant pressure is normal, compressor and clutch engage and work properly when power is sent out directly. All fuses and relays are good.

Honda Air conditioning low pressure switch has been an worry in the past and causes an intermittent air air conditioning operation. A/C started to work usually after brand-new sensor was installed.

Pressure switch Removal.

It is not difficult as there is enough an are and is quite available to work-related on. Honda Air conditioning low press switch is situated under the hood on passenger side, right beside Abs pump.

There will certainly be no refrigerant lose while removed the switch and also no require to drain the system, that is plug and also play.

Tools: 24mm deep socket, ratchet and and extension.


*
24mm socket and ratchet is needed

Unclip electric plug from sensor, usage socket to ease switch and also unscrew it.

Air air conditioning lines in ~ the basic of push switch housing are thin and also fragile. Got to be cautious how much pressure you apply or lines can break i m sorry will cost quite a little bit to fix.


Pressure Switch

A/C lines space fragile and also need come be hosted in ar when unscrewing sensor. Use a driver or something similar between air conditioning lines and car chassis to host them while you shot to loosen it. This job could require some help and one extra pair the hands.

Low Pressure switch Installation.

Once old sensor is removed, just screw new sensor in and also tighten it. Again watch just how much pressure you use, don’t overkill it. Plug electric switch. Start your used auto and try if air air conditioning is working. Hopefully now it is.

See more: Prime Factorization Of 40 Using Exponents When Needed? Prime Factorization Calculator

If you got bored through it and also decide to offer your used vehicle then there room several choices you can explore: Where and How to sell Your Car.

Comments: If girlfriend have any kind of remarks and also suggestions related to this post or Used automobile Toronto in general, nothing hesitate to usage comment ar below